Getting Started; Battery Installation; Battery Notice - VTech PJMASKS Parents' Manual

GETTING STARTED

BATTERY INSTALLATION

1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the unit. Use a coin or screwdriver to
loosen the screw.
3. Install 2 new AA (LR6/AM-3) batteries into
the compartment as illustrated. (The use
of new alkaline batteries is recommended
for maximum performance.)
4. Replace the battery cover and tighten the
screw to secure.

BATTERY NOTICE

• Use new alkaline batteries for maximum performance.
• Use only batteries of the same or equivalent type as recommended.
• Do not mix different types of batteries: alkaline, standard (carbon-zinc)
or rechargeable, or new and used batteries.
• Do not use damaged batteries.
• Insert batteries with the correct polarity.
• Do not short-circuit the battery terminals.
• Remove exhausted batteries from the toy.
• Remove batteries during long periods of non-use.
• Do not dispose of batteries in fire.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging (if
removable).
• Rechargeable batteries are only to be charged under adult supervision.
80-175900 rev IM.indd 4
4
2017/10/10 10:43:09