VTech InnoTab 2 User Manual page 29

No picture (or
incorrect picture) on
screen, and pressing
the Power button has
no effect.
No screen display
after pressing Power
button.
The cartridge icon
does not appear on
desktop.
USB connection
window does
not pop up after
connecting to
computer.
Clock time is not
accurate.
Touch screen is
inaccurate or it is
impossible to select
the correct icon on
the screen.
Program needs to be
reset.
Battery power low.
Incomplete battery
installation.
No AC adaptor power.
Poor cartridge
connection.
Poor USB cable
connection.
Connection is running
through USB hub.
Backup battery power
low.
Touch screen requires
calibration.
Disconnect all power supplies
(batteries and adaptor), then
reconnect all power supplies.
Press the Power button.
Remove the cartridge, clean it if
necessary, and then re-insert it
into the InnoTab 2.
®
Replace the battery.
Make sure to install all batteries
in the battery compartment.
Securely connect the AC
adaptor or car adaptor to both
the InnoTab 2 and the power
®
source.
Remove the cartridge, clean it if
necessary, and then re-insert it
into the InnoTab 2.
®
Securely connect the USB cable
to InnoTab 2 and the computer.
®
Connect the InnoTab
to the computer, without using
a hub.
Replace backup battery (for
backup battery replacement
instructions, please see the
Care & Maintenance section on
page 23).
Turn the InnoTab
hold , and
when turning the InnoTab
Follow the steps on the screen.
2 directly
®
2 OFF. Then
®
down
2 ON.
®
25