Water Separator Buzzer Sounds - Honda BF75D Owner's Manual

COOLING SYSTEM INDICATOR
If overheating activates the engine
protection system, idle the engine in
neutral, and check the cooling system
indicator.
TAKING CARE OF UNEXPECTED PROBLEMS
If water is flowing from the cooling
system indicator, continue idling for
30 seconds. If the cooling system is
OK, the overheat indicator should go
off within 30 seconds, and the engine
will respond normally to throttle
control lever operation.
If there is no water flowing from the
cooling system indicator, stop the
engine, and tilt the outboard motor to
inspect the water intake screens. If
restricted, clean the water intake
screens, return the outboard motor to
the running position, restart the
engine, and check the cooling system
indicator again.
If there is still no water flowing from
the cooling system indicator, or if the
engine protection system remains
activated after 30 seconds, return to
the nearest boat landing, and have the
outboard motor inspected by an
authorized Honda Marine dealer.
WATER SEPARATOR
BUZZER SOUNDS
WATER SEPARATOR
When the water separator buzzer
sounds (a rapid, repeating signal):
Check the water separator for water
contamination. If water is
accumulated, stop the engine, and
clean the water separator following
the instructions on page 93, or consult
with an authorized Honda Marine
dealer.
119