Honda BF75D Owner's Manual page 97

BAFFLE
PLATE
O-RING
(Replace)
BODY
SCREW (3)
WATER
SEPARATOR CUP
7. Remove the three screws and
separate the water separator cup
from the body.
8. Thoroughly clean the water
separator cup.
9. Reassemble the water separator in
the reverse order of removal. Use a
new O-ring. 
TIGHTENING TORQUE: 
3.1 lbf·ft (4.2 N·m, 0.43 kgf·m)
• Assemble so the flat part on the
back of the suspension is parallel to
the water separator joint as shown
below.
Assemble so the flat part of the
suspension and the water separator joint
are parallel to each other.
SUSPENSION
STRAP
WATER
SEPARATOR
FLAT PART ON BACK
OF SUSPENSION
SERVICING YOUR OUTBOARD MOTOR
POSITIONING
BAND
JOINT
10. Connect the water level sensor 2
11. Reinstall the water separator in
WATER LEVEL
SENSOR 2 pin
CONNECTOR
HARNESS
CLIP
POSITIONING
CLIP C
BAND
pin connector. Install the harness
to clip C and the harness clip. 
Align the positioning bands on
the harness with the end of clip C
and the harness clip as shown
above.
the reverse order of removal.
95