Water Separator Buzzer Sounds; Water Separator Indicator - Honda Marine BF75D Owner's Manual

TAKING CARE OF UNEXPECTED PROBLEMS
If water is flowing from the cooling
system indicator, continue idling for
30 seconds. If the cooling system is
OK, the overheat indicator should go
off within 30 seconds, and the engine
will respond normally to throttle
control lever operation.
If there is no water flowing from the
cooling system indicator, stop the
engine, and tilt the outboard motor to
inspect the water intake screens. If
restricted, clean the water intake
screens, return the outboard motor to
the running position, restart the
engine, and check the cooling system
indicator again.
If there is still no water flowing from
the cooling system indicator, or if the
engine protection system remains
activated after 30 seconds, return to
the nearest boat landing, and have the
outboard motor inspected by an
authorized Honda Marine dealer.
126
WATER SEPARATOR
BUZZER SOUNDS
WATER SEPARATOR
When the water separator buzzer
sounds (a rapid, repeating signal):
Check the water separator for water
contamination. If water is
accumulated, stop the engine, and
clean the water separator following
the instructions on page 100
consult with an authorized Honda
Marine dealer.
WATER SEPARATOR
INDICATOR
Digital Speedometer
Normal
Abnormal
When the water separator indicator
blinks:
Check the water separator for water
contamination. If water has
accumulated, stop the engine, and
clean the water separator following
, or the instructions on page
consult with an authorized Honda
Marine dealer.
100 , or