CAUTION: If you need to continuously reset the heater, Figure 2 disconnect power and call Dimplex customer service at 1-888-DIMPLEX (1-888-346-7539). Button Remote Control The fireplace is supplied with a radio frequency remote Off Button control.
(Figure 4). ! NOTE: Ensure the log set is installed tightly under the back ledge to prevent light leakage. Mirror 9. Replace glass assembly. Ember Bed Assembly Back Ledge Rear Tab Front Edge Side Section www.dimplex.com...
PREPARATION FOR SERVICE LIGHT HARNESS REPLACEMENT CAUTION: If unit was operating prior to servicing allow Tools required: Phillips head screw driver at least 10 minutes for lights, heating elements and top Small wire cutter panel to cool off to avoid accidental burning of skin. CAUTION: Follow “Preparation for Service”...
(2) on the top. Take note of the orientation on the brackets. 2. Lift the top off the firebox. Turning the panel 45 de- 8. Place the new motor into the housing and attach the www.dimplex.com...
grees, rest it inside the cavity in the top to provide you are engaged. with some support and leverage while following Step 4. 8. Re-assemble in reverse order as described above. CAUTION: Support the back underside of the firebox THERMOSTAT REPLACEMENT with a small piece of wood as the feet do not go the entire depth of the unit and it can easily tip backwards.
4. Remove the old board off the plastic mounts, by squeezing the tab inward and sliding the board off. 5. Replace any plastic mounts that may have broken by pushing the old mounts out towards the top. Replace www.dimplex.com...
ASSEMBLY PART PICTURES LOWER ELECTRICAL HOUSING VIEW FROM THE BOTTOM Flicker Motor Lower Terminal Block Flicker Motor Connection - White (with capacitor wire) Light Harness Connection - Neutral Capacitor - Connects to the ter- minals with the brown and white wires from the flicker motor Light Harness Connection - Live...
Red - From the high temperature cutout to the terminal block. HEATER ASSEMBLY CONNECTIONS WITH HIGH TEMPERATURE CUTOUT View of Heater Assembly removed from the top panel High Temperature Cutout Element Housing Blower Housing Blower Motor Upper Panel Terminal Block www.dimplex.com...
REMOTE CONTROL RECEIVER BOARD CONNECTIONS VIEW FROM THE TOP RIGHT SIDE Stand-Off Clips (4) - Attaching receiver board to housing Switch Output (Black) to outside prong of 3-Position Switch JP1 - Connects to inside Switch Output (Black “Piggy prong of 3-Position Switch Back”) to “Piggy Back”...
Replace Light Harness Log set dim, not glowing Loose wiring Check wiring connections (BF9000 only) Defective LED Log Driver Board Replace LED Log Driver Board Defective Log Set Assembly Replace Log Set Assembly Flame Shutter Defective Flicker Motor Replace Flicker Motor www.dimplex.com...
Page 17
Light leaking around the log set Log set not positioned properly Check log set for proper fit PROBLEM CAUSE SOLUTION Heater Heater is not turning off Improper operation Refer to Operation Section Defective Heater Switch Replace Heater Switch Defective Thermostat Replace Thermostat Defective Remote Control Receiver Replace Remote Control Receiver...