Charging The Battery - Chicago Electric 92880 Set Up And Operating Instructions Manual

When unpacking, check to make sure the following parts are included.
9.6V Rotary Tool with Battery
LED Light Attachment
AC/DC Transformer
9.6V Battery Charger Base
3- piece Cutoff Wheel Set
4-piece Sanding Drum Set
36-piece Sanding Disc Set
2-piece Buffing Wheel Set
2-piece Brass Collet Set
2-piece Drill Bit Set
10-piece Mounted Stone Set
2-piece Diamond Burr Set
Flat Wrench
Square Stone Dresser
Plastic Carrying Case
If any parts are missing or broken,
please call Harbor Freight Tools at the
number on the cover of this manual.
Charging the Battery pack:
1. Battery packs are normally shipped with low or no charge to prevent
potential problems during shipment. Before use, you must charge your new
battery pack. note: Time to charge battery is approximately 3 to 3-1/2
hours.
Battery
Transformer
Charger Base
SKU 92880 For technical questions please call 1-800-444-3353
unpacking

Charging the Battery

note: Batteries will not reach
full charge the first time they are
charged. Allow several cycles
(operation followed by recharging)
before the battery will become
fully charged.
PHOTO: Rechargeable Battery
in Battery Charger Base which is
plugged into the Transformer.
reV 07h; 07j
Page 5