Charging The Battery Pack; Installing Attachments; Work Piece And Work Area Set Up - Chicago Electric 67707 Set Up And Operating Instructions Manual

Work piece and Work area Set up

1. Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
2. Route the power cord of the Charger
along a safe route without creating a
tripping hazard or exposing the power
cord to possible damage.

charging the Battery pack

The Battery Pack needs to be charged
before first use. It is recommended to
recharge the Battery after every use.
Charger (506)
Charger Plug
figure 2
1. Place the Battery Pack on a dry fireproof
surface in a room where the temperature
ranges from 33-112° F.
2. Allow a recently exhausted Battery Pack
to cool completely before charging. Make
sure the Battery Pack is undamaged; do
not charge a cracked or leaking pack.
3. Insert the Charger's plug into the
Charger Socket on the Battery Pack, and
plug the Charger into a grounded, 120V
outlet. The indicator light on the Charger
will turn red showing that the battery is
charging.
4. When the indicator light turns green,
the Battery Pack is fully charged. This
process will take approximately 90
minutes.
SKU 67707
Indicator Light
Charger
Socket
for technical questions, please call 1-800-444-3353.
5. Unplug the Battery Pack from the
Charger and the Charger from the wall
outlet.
note: Do not use a battery pack immediately
after charging. Allow it to cool first. Store
the Charger and Battery Packs not in
use indoors, away from children.

installing attachments

1. To install an accessory:
a. Hold the Spindle (3) with a 13mm
wrench (sold separately), and unthread
the Cap Screw (1) using the Hex
Wrench (505). Remove the Cap Screw
and Retainer (2).
Battery
Pack
Cutting Blade
(502)
figure 3
b. Install the desired accessory in any one
of seven forward orientations by aligning
four of the holes in the accessory over
the four pins on the Spindle.
caution: Always face the accessory away
from the handle to avoid injury.
to preVent
SeriouS injurY
from accidentaL
operation:
make sure the Battery pack is
removed from the tool before
installing accessories, or
adjusting the tool.
Four Pins on
Spindle (3)
Page 9