Technical Specifications; Replacing A Power Supply Module - Dialogic 3000 Series Quick Start Manual

Technical Specifications

Environmental requirement:
Operating temperature: 10 degrees Celsius to 35 degrees Celsius
CPU
Memory
Dimensions in mm
Height:
Width:
Length:
External interface
Internal interface
Power supply

Replacing a power supply module

To replace the power supply module (PSM), do the following:
1. If you have two power supply modules, verify which one has failed. The LED next to the green handle is lit
red if the PSM failed.
2. Disconnect the power cord.
Note: You only need to disconnect the power cord of the PSM that failed. The power cord of the functioning
PSM can remain plugged.
3. Slide the green safety lock to the left.
4. Grasp the green handle and pull the PSM out.
5. Take the new PSM and insert it into the box. Make sure to keep the green safety lock pressed to the left
while inserting the PSM.
Dialogic® 3000 and 4000 Media Gateway Series Quickstart Guide
®
Dialogic 3000 Media Gateways
Intel Pentium IV processor; 2.8 GHz
1 GB DDR SDRAM (400MHz)
44
430
390
2 USB (2.0) ports
VGA port
RS232 Serial port
2 x Gigabit-Ethernet ports
32 bit; PCI (5 V)
100-240 Vac
50/60 Hz
4 A
®
Dialogic 4000 Media Gateways
Intel Xeon 5160 Dual Core processor; 3.0GHz
2 GB DDR2 ECC SDRAM (667MHz)
44
430
508
3 USB (2.0) ports
VGA port
RS232 Serial port
4 x Gigabit-Ethernet ports
64 bit; PCI (3.3 V)
2 power supplies; each with:
100-240 Vac
50/60 Hz
4/2 A
page 25