Page 2
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instruction manual, may cause interference to radio...
Page 3
ASIC to ensure the utmost in reliability and compatibility. Setup is as easy as can be - simply connect the computer system box and local console to the Local CE-700 Module; run the Cat 5 cable to the Remote CE-700 Module (up to 150 meters away);...
Page 4
Features Cat 5 cable to connect the local and remote units – up to 150 meters apart Auto Signal Compensaton (ASC) USB Keyboard and USB Mouse Ports Dual console operation – control your system from both the local and remote USB keyboard, monitor, and mouse consoles USB overcurrent detection and prevention Push button selection of the active console...
KVM Cable that is provided with this package. Cat 5 cable is the minimum required to connect the local and remote CE-700 units. Cable of a lesser standard will result in degrading the video signal. For best performance, we strongly recommend Cat 5 cable.
Components The Local Unit (CE-700L) Front View: Description Function Operating Mode Pressing this button toggles between the operating Selection Switch mode choices: Local: only the local console can control the system(s) Auto: both consoles can control the system(s). LEDs The Local Unit has two LEDs to indicate the operating status of the Local and Remote units (see CE-700L (Local Unit), p.
Page 7
The HDB-15 video connector of the USB KVM Custom Cable supplied with this package plugs in here. Note: If you are combining the CE-700 with a KVM switch, the KVM cable connects back to the respective ports on the Console section of the switch.
Page 8
The Remote Unit (CE-700R) Front View: Description Function LEDs The Remote Unit has two LEDs (Power and On Line) to indicate the operating status of the Local and Remote units (see CE-700R (Remote Unit), p. 11). USB Keyboard The remote USB keyboard and USB mouse plug into and Mouse Ports these connectors.
Installation Setting up the CE-700 KVM Extender system is simply a matter of plugging in the cables. Refer to the installation diagram on the following page and do the following: 1. Make sure that all the equipment to be connected up is powered Off.
Operation The Local and Remote Units each have two LEDs to indicate their operating status, as shown in the tables, below: CE-700L (Local Unit) LEDs Operating Mode Local Auto Local Console Active Flash Remote Console Active Flash Error / Disconnect Not Ready Neither Console Active CE-700R (Remote Unit)
Troubleshooting Problem Action No video Make sure that all cables are securely plugged into their sockets. Poor video quality. The video quality can be improved by reducing the refresh rate. Specifications Function CE-700L CE-700R Connectors Keyboard 2 x 6-pin Mini-DIN F 1 x 6-pin Mini-DIN F Mouse 2 x 6-pin Mini-DIN F...
Limited Warranty IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY EXCEED THE PRICE PAID FOR THE PRODUCT FROM THE DIRECT, INDIRECT, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE PRODUCT, DISK OR ITS DOCUMENTATION. The direct vendor makes no warranty or representation, expressed, implied, or statutory with respect to the contents or use of this documentation, and specially disclaims its quality, performance, merchantability, or fitness for any particular purpose.