Programming Your User-Defined Satellites - KVH Industries Cars 2 Innotab User Manual

Programming Your User-Defined Satellites

To configure a user-defined satellite, you will need to program into the
antenna the following information about the satellite:
• Satellite name
• Satellite longitudinal position
• Transponder information for all four combinations of
polarization and band (vertical high, vertical low,
horizontal high, and horizontal low):
• Frequency
• Symbol rate
• FEC code
• Network ID
• Decoder type
NOTE: You can find this information on the web at
www.satcodx.com
To program this information into the antenna, enter the following
commands via Windows HyperTerminal (see
the Antenna" on page
1. Type HALT then press Enter.
2. Type the following SATCONFIG command then press
Enter:
SATCONFIG,X,A,B,C,D
3. Type @DEBUGON then press Enter.
(neither website is affiliated with KVH).
69).
Field Description
X User-defined satellite stored in antenna library
(996W = User A; 997W = User B)
A Longitude (0-180)
B E (East) or W (West)
C Decoding type (1 = DSS-A, 2 = DSS-B, 3 = DVB)
D Polarization (L = linear)
TracVision M3/M2 User's Guide
Appendix C - Programming User-Defined Satellites
www.lyngsat.com
"Connecting a Laptop to
or
71