Changing Tracking Parameters - KVH Industries Cars 2 Innotab User Manual

Changing Tracking Parameters

On rare occasions, a satellite service provider may change the
configuration of one of its satellites. Since your TracVision antenna
identifies a satellite based on the configuration data it has stored in
memory, the antenna will no longer be able to track the satellite if its
configuration changes. For this reason, the interface box allows you to
change any satellite parameter stored in the antenna's memory.
IMPORTANT!
Change tracking parameters only if directed by KVH Technical
Support. An incorrect tracking parameter can significantly reduce
the performance of the antenna.
Follow the steps below to change a tracking parameter for an installed
satellite.
1. Press
"DIAGNOSTICS."
2. Press
"DIAGNOSTICS= YES."
3. Press
MENUS until the display shows
DIAGNOSTICS= NO
NEXT MENU
CHANGE until the display shows
DIAGNOSTICS= YES?
CHANGE
ACCEPT to enter the Diagnostics menu.
TracVision M3/M2 User's Guide
Chapter 5 - Troubleshooting
CHANGE
ACCEPT
53