Calibrating The Gyros - KVH Industries Cars 2 Innotab User Manual

Calibrating the Gyros

The TracVision antenna's gyros continuously measure the motion of
your vessel and send this data to the antenna's motor control circuitry
to keep the antenna pointed at the satellite. At the factory, each
antenna gyro is precisely calibrated to work with the antenna's circuit
board. Therefore, if you ever replace a gyro or circuit board in your
antenna, you will need to recalibrate the gyros for the new part.
Follow the steps below to calibrate the gyros.
IMPORTANT!
Calibrate the gyros only if directed by KVH Technical Support, and
only while the vessel is stationary. A poor gyro calibration can
reduce the performance of the antenna.
1. Press
"DIAGNOSTICS."
2. Press
"DIAGNOSTICS= YES."
3. Press
MENUS until the display shows
DIAGNOSTICS= NO
NEXT MENU
CHANGE until the display shows
DIAGNOSTICS= YES?
CHANGE
ACCEPT to enter the Diagnostics menu.
ENTERING DIAGNOSTICS
TracVision M3/M2 User's Guide
Chapter 5 - Troubleshooting
CHANGE
ACCEPT
51