TracVision M3/M2 User's Guide
Chapter 5 - Troubleshooting
52
SYSTEM RESET= NO
NEXT MENU
4. Press
MENUS until the display shows "CAL GYRO."
CAL GYRO= NO
CHANGE
5. Press
CHANGE until the display shows "CAL
GYRO= YES."
CAL GYRO= YES
CHANGE
6. Press
ACCEPT to start gyro calibration.
CALIBRATING GYRO
AZ:
7. Verify that the azimuth (AZ) and elevation (EL) gyros
both pass. If either gyro does not pass, retry the
calibration. If it continues to fail, please seek technical
support (see
"Technical Support" on page
CALIBRATION COMPLETE
AZ: PASS
8. Once the gyros are calibrated, the antenna restarts.
CHANGE
ACCEPT
ACCEPT
EL:
57).
EL: PASS