Source Technologies ST9720 User Manual page 48

Programming Related Errors
Error Message
on Display
Can't Create
Node
Can't Purge,
password not
enabled
Can't Sort
Insufficient
Memory
Command Decode error
Decode Error &%Sx (where
x is the
incorrect
character)
File System
Error Can't Open
File
Flash Full Purge
and Format
Integer string Integer string
incorrect length incorrect
length
Invalid
AES/DES key
Invalid Convert Invalid
to Escape Convert to
Character Escape
Character
Source Technologies, LLC
Printed
Description
Message
There was insufficient
memory to track
another audit job
This error indicates that
MICR mode has not
been enabled.
This error indicates the
printer does not have
sufficient memory to
sort the Audit Report.
A syntax error was
detected in a MICR
command.
There was an internal
error while trying to
access flash for audit
trail
This error message
indicates that the
printer's flash memory
is full. The audit trail
cannot accept more
jobs until more space is
available in flash.
A parameter in a
command was not the
correct length.
Invalid hex digit or
length of decryption
key
An error was detected
in the User
Programmable Escape
Character Selection
Command. The
software tried to
specify a NULL or an
ampersand as the first
Escape Character.
44
Error Messages | 8
Action
Turn printer off and back
on, then retry. If the
problem recurs, call Tech
Support.
Press Go. Enter MICR
mode, then re-attempt the
purge.
Press Go. The printer
may need to be upgraded
with more RAM memory
to sort; otherwise an
unsorted Audit Report
may be printed.
Check your software for a
syntax error in the MICR
command that was being
used when the error
occurred.
Check that Flash is
installed and not full.
Press Go then purge the
audit trail. Then either
defragment or format flash
memory (Utilities Menu).
Check the Command
(&%STP, STS) for
syntax/numbering errors.
Check the syntax of
SETAESKEY or
SETDESKEY command.
Check the Command
(&%STY...) for errors.
ST9720 Secure MICR Printer User's Guide