Table of Contents
Advertisement
3. Hardware Installation
Start up
Please refer to the followings for your cabling:
10/100Base-TX
All
10/100Base-TX
automatically support 100Base-TX and 10Base-T networks. Users only need to
plug a working network device into one of the 10/100Base-TX ports, and then
turn on the FSD-808P. The port will automatically runs in 10Mbps, 20Mbps,
100Mbps or 200Mbps after the negotiation with the connected device.
Cabling
Each 10/100Base-TX ports use RJ-45 sockets -- similar to phone jacks -- for
connection of unshielded twisted-pair cable (UTP). The IEEE 802.3 / 802.3u Fast
Ethernet standard requires Category 5, 5e UTP for 100Mbps 100Base-TX. 10Base-T
networks can use Cat. 3, 4, 5 (see table below). Maximum distance is 100meters
(328 feet).
Port Type
10Base-T
100Base-TX
Any Ethernet devices like hubs/ PCs can connect to the FSD-808P by using
straight-through wires. The eight-10/100Mbps ports are auto-MDI/MDI-X can be
used on straight-through or crossover cable.
3.1 Desktop Installation
To install the Switch on desktop, simply follow the next steps:
Step 1: Attach the rubber feet to the recessed areas on the bottom of the Switch,
as shown in Figure 3-1.
Figure 3-1: Attaching the Rubber Feet to the POE Fast Ethernet Switch
10
ports
come
with
Cable Type
Cat. 3, 4, 5, 2-pair
Cat. 5, 5e UTP, 2-pair
Auto-Negotiation
capability.
Connector
RJ-45
RJ-45
They
Advertisement
Table of Contents
