Communication Test - GE Simon XT V2 User Manual

Table 14: Tripping sensors for sensor test
Device
Door/window sensor
Freeze sensor
Water sensor
Carbon monoxide sensor
Glassbreak sensor
Motion sensor
Shock sensor
Smoke sensor
Wireless panic button
Key fob
Simon XT talking touch screen
Simon XT talking touchpad
Remote handheld touchpad

Communication test

Test communication between your system and the central monitoring station or a
voice report destination at least once a week to make sure you have the proper
telephone connection.
Note: The system must be in disarm mode.
To perform a communication test:
1. Scroll until the display shows System Tests, and then press OK.
The display shows Enter Code.
2. Enter your master code, and then press OK.
The display shows Comm Test.
3. Press OK.
The display shows Comm Test is On.
After the communication test is successful, the display shows Comm Test OK.
Simon XT V2 User Manual
To trip device
Open the secured door or window.
Apply ice to the sensor. Do not allow the sensor to get wet.
Press a wet rag or wet finger over both of the round, gold-plated
terminals on the underside of the sensor.
Unplug the CO alarm. Plug it back in and press the test/reset button
until the unit beeps eight times.
Trip with appropriate glassbreak tester.
Avoid the motion sensor's view for 5 minutes, and then enter its view.
Tap the glass twice, away from the sensor. Wait at least 30 seconds
before testing again.
Press and hold the test button until the system sounds transmission
beeps.
Press and hold the appropriate button for 3 seconds.
Press and hold Lock and Unlock simultaneously for 3 seconds.
Press and hold the Emergency button for 5 seconds.
Press and hold the two Emergency buttons simultaneously for 3
second.
Press and hold the two Emergency buttons simultaneously for 3
seconds.
31