GE Simon XT V2 User Manual page 29

Timers
The latchkey time option is the only timer setting available to you. The latchkey time is
the time of day by which the panel must be disarmed to avoid triggering a latchkey
alarm, if the latchkey time option is enabled during arming.
To change the latchkey time:
1. Enter the System Programming menu.
2. Scroll until the display shows Timers, and then press OK.
3. Scroll until the display shows Latchkey Time, and then press OK.
The HH (hours) part of the time flashes.
4. Program the hours value by scrolling or entering a numerical value, and then
press OK.
The MM (minutes) part of the time flashes.
5. Program the minutes value by scrolling or entering a numerical value, and then
press OK.
If you are using 12-hour clock format, the A or P (AM/PM) part of the time flashes.
6. Select A or P by scrolling, and then press OK.
7. Press Status repeatedly to exit.
Sirens options
The panel has two built-in sound sources, a piezo siren and a speaker. The piezo siren
makes alarm beeps and status beeps. Fire and intrusion alarm beeps are always
played at high volume, while the volume of status beeps (such as trouble or chime
beeps, entry and exit delay beeps, or auxiliary alarm beeps) is programmable. The
speaker emits the panel's voice and sounds beeps when a key is pressed. Its volume
is also programmable.
The siren and built-in speaker options consist of the following:
Panel piezo beeps. (Status beeps sounded on the siren.) This option determines
whether the panel sounds nonalarm beeps. To program piezo beeps:
1. Enter the System Programming menu.
2. Scroll until the display shows Siren Options, and then press OK.
3. Scroll until the display shows Piezo Beeps, and then press OK.
The current value of this option flashes (On or Off).
4. Scroll to the desired value, and then press OK.
5. Press Status repeatedly to exit.
Simon XT V2 User Manual 27