Table of Contents
Advertisement
3-3) SYSTEM SET MENU function setting
You may change DWELL TIME, PIP POSITION, BORDER COLOR, LOSS CHANNEL COLOR,
SYSTEM ID.
e-32
If you click the UP/DOWN button to select 3. SYSTEM SET in the SETUP MENU and click the
ENTER button, the following screen will be displayed.
[SYSTEM SET]
DWELL TIME...
PIP POSITION
BORDER COLOR
LOSS CHANNEL COLOR
SYSTEM ID
-
Select an item with the UP/DOWN button and change the preset value with the
LEFT/RIGHT button.
-
Press the MENU button after completing all the settings to return to the SETUP MENU.
DWELL TIME...
•
Select DWELL TIME... with the UP/DOWN button and click the ENTER button.
Then the following screen pops up.
[DWELL TIME]
CH1
03[SEC]
CH5
CH2
03[SEC]
CH6
CH3
03[SEC]
CH7
CH4
03[SEC]
CH8
QUAD-A 03[SEC]
QUAD-B 03[SEC]
•
Use the UP and DOWN buttons to move the item you want to set, and then use
the LEFT and RIGHT buttons to change the setting value.
•
Press the MENU button after completing the settings to return to the SYSTEM SET Menu.
BOTTOM-RIGHT
GRAY
BLACK
1..
03[SEC]
03[SEC]
03[SEC]
03[SEC]
PIP POSITION: BOTTOM-RIGHT
TOP-LEFT
•
Select the PIP position among the four options listed above.
BORDER COLOR: GRAY
WHITE
BLACK.
•
GRAY : BORDER LINE COLOR is displayed in GRAY in Multi Screen mode
•
WHITE : BORDER LINE COLOR is displayed in WHITE in Multi Screen mode
•
BLACK : BORDER LINE COLOR is displayed in BLACK in Multi Screen mode.
LOSS CHANNEL COLOR: BLACK
BLUE.
•
BLACK: The area corresponding to the channel where video loss has occurred will be
displayed in black.
•
BLUE: The area corresponding to the channel where video loss has occurred will be
displayed in blue.
SYSTEM ID
•
This function allows the user to control a single monitor using the remote control when
multiple (up to 10) monitors are linked together.
Only those monitors with IDs matching the Remote Control ID will be controlled by the
remote control.
09/01/03 12:30:00
QUAD-A
CAM1
CAM2
MONITOR ID:1 REMOCON ID:1
CAM3
CAM4
•
Setting : : The default value of the monitor and remote control 1 . The value of the
Monitor ID can be set from 0 to 9 by accessing the SYSTEM ID Setup mode under the
SYSTEM SET menu. Press the SYSTEM ID button on the remote control to display
the Monitor ID and the Remote Control ID as shown above. Enter the desired number by
pressing the corresponding button (0 to 9) to set up the Remote Control ID.
The OSD will disappear four seconds after the last button is pressed.
TOP-RIGHT
BOTTOM-LEFT.
e-33
Advertisement
Table of Contents
