Table of Contents
Advertisement
3-2) DATE/TIME MENU Function setting
•
Function: Sets the display date format and current time.
Setting method :Move to #2. DATE/TIME MENU by using œ œ ENTER√ √ SWITCH at setup menu,
•
then press the ENTER SWITCH to display the OSD as shown in the below figure.
(The figure shows the initial setting status.)
06/01/03
DATE/TIME SETTING
DATE TYPE
DATE
TIME [HH:MM:SS]
•
Setting method of date display format
Move to the format item by turning œ œ ENTER√ √ SWITCH, and enter the mode for setting date
format by pressing the ENTER SWITCH.
At this time, select a target date format by turning left and right the SWITCH.
("YY/MM/DD", "MM/DD/YY", "DD/MM/YY" are available for selectable data format.)
•
Date and current time setting method
Repeat the above instruction for moving to each item (MONTH, DAY, YEAR, HOUR, MINUTE,
SECOND) and entering the mode. Current date and time to display can be set. (It can be referred
when ALARM or LOSS occurs.)
3-3) DWELL TIME MENU function setting
•
Function : Displays each picture for pre-set time and automatically switches it to the next picture
at SEQUENTIAL DISPLAY MODE.
Setting method : Move to #3. DWELL TIME menu by using œ œ ENTER√ √ SWITCH at SETUP
•
MENU, and press the ENTER SWITCH to display the following OSD as shown in the below
figure. (The figure shows the initial setting status.)
06/01/03
DWELL TIME SETTING
CAM1
CAM2
CAM3
CAM4
CAM5
CAM6
CAM7
CAM8
QUAD-A
QUAD-B
If the time is set for each camera channel by using œ œ ENTER√ √ SWITCH, each camera picture will be
displayed for the set time and switched to the next picture automatically.
13:14:00
MM/DD/YY
06 / 01 / 03
13 : 14 : 00
13:14:00
01 SEC
01 SEC
01 SEC
01 SEC
01 SEC
01 SEC
01 SEC
01 SEC
01 SEC
01 SEC
English-38
Advertisement
Table of Contents
