Honda BF200A Owner's Manual page 98

TAKING CARE OF UNEXPECTED PROBLEMS
7. Close the junction box cover and
reinstall the engine cover (p. 61).
8. Reconnect the battery.
Never use a fuse with a rating greater
than specified. Serious damage to the
electrical system could result.
If a blown fuse is found, try to
determine and correct the electrical
problem that caused the blown fuse.
An uncorrected electrical problem
may cause the fuse to blow again.
If fuses continue to blow, take the
outboard motor to an authorized
Honda Marine dealer for inspection
and service, or refer to the shop
manual.
96
ACG Fuse
5 mm SCREWS
JUNCTION
BOX COVER
PAWLS
SPARE FUSE (150 A)
Replacement
1. Stop the engine.
ACG FUSE
2. Disconnect the battery.
(150 A)
3. Remove the engine cover (p. 61).
4. Open the junction box cover.
5. Remove the old fuse by removing
two 5 mm screws.
6. Install a new fuse by tightening two
5 mm screws.
ACG FUSE: 150 A
7. After finishing replacement, close
the junction box cover.
8. Install the engine cover (p. 61).
9. Reconnect the battery.