Honda BF200A Owner's Manual page 47

Outboard motor
Hide thumbs Also See for BF200A:
Table of Contents

Advertisement

If the engine fails to start within 5
seconds, release the key and wait at
least 10 seconds before operating
the starter again.
• Using the electric starter for more
than 5 seconds at a time will
overheat the starter motor and can
damage it.
• Turning the ignition switch key to
the START position while the
engine is running can damage the
starter motor and flywheel.
N (NEUTRAL)
CONTROL
LEVER
FAST IDLE BUTTON
5. Before getting underway, allow the
engine to warm-up sufficiently to
ensure good performance.
Above 41°F (5°C), warm-up the
engine for 2 or 3 minutes.
Below 41°F (5°C), warm-up the
engine for at least 10 minutes at
2,000 rpm. Push the fast idle
button, and then move the control
lever forward or reverse to open the
throttle and achieve approximately
2,000 rpm.
OPERATION
• If the engine is not properly
warmed up before raising the
engine speed, the buzzer and
overheat indicator may activate
and the engine speed will be
automatically reduced.
• The cooling system may freeze in
areas where the temperature
reaches 32°F (0°C) or below.
Cruising at high speed without
warming the engine up may cause
engine damage.
45

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bf225aMarine bf200a

Table of Contents