Paradyne 6381 Installation Instructions Manual page 5

4.
INSTALL WHITE FERRITE CLAMP. If you
plugged in a phone, install the supplied
white ferrite clamp around both the LINE
and PHONE cables. If you did not plug in a
phone, install the white clamp around the
LINE cable.
Hold the open clamp around the cable or
cables as close to the router as possible.
Close the clamp and lock it by pressing on
the latch.
5.
CONNECT TO PC OR ETHERNET HUB. Use an 8-pin Ethernet cable
(straight-through or crossover) for the Ethernet connection. Insert one end of the
cable into the jack labeled ETHERNET.
Connect to one of the following:
— PC. Use an Ethernet standard,
straight-through cable and connect
the other end to a PC with an
Ethernet Network Interface Card
(NIC) installed.
– or –
— Ethernet Hub. Use an Ethernet
standard, straight-through cable
and connect the other end to an
Ethernet hub's Uplink port. (To
connect to a hub's standard port,
use an Ethernet crossover cable.
See the documentation that came
with your hub.)
6.
INSTALL BLACK FERRITE CLAMP.
Hold the open clamp around the
Ethernet cable as close to the router as
possible. Close the clamp and lock it by
pressing on the latch.
PHONE
PC with Ethernet
Network Interface
Card
Ethernet
Hub
4
5
6
7
8
5
LINE
ETHERNET
Ethernet
Crossover
Cable
ETHERNET
1
2
3
Ethernet
Crossover
Cable