Supplier's Declaration Of Conformity - Paradyne 6381 Installation Instructions Manual

Declaration of Conformity
This Declaration of Conformity is made by Paradyne Corporation pursuant to Parts 2 and 15 of the Federal
Communications Commission's Rules. This compliance information statement pertains to the following products:
Trade Name:
Model Number:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
The name, address, and telephone number of the responsible party is given below:
Paradyne Corporation
8545 126th Avenue North
Largo, FL 33773-1502
Phone: (727) 530-2000
The authority to operate this equipment is conditioned by the requirement that no modifications will be made to
the equipment unless the changes or modifications are expressly approved by Paradyne Corporation. The
supplied ferrite clamps must be installed as instructed to ensure compliance with Part 15, FCC Rules.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Supplier's Declaration of Conformity

Place of Issue: Paradyne Corporation
8545 126
Largo, FL 33773-1502
USA
Date of Issue: 02/26/2003
Paradyne Corporation, located at the above address, hereby certifies that the Hotwire® ADSL/R Bridge/Router
Model Number 6381-AX-210, bearing labeling identification number US:AW2DL03B6381-AX complies with: the
Federal Communications Commission's ("FCC") Rules and Regulations 47 CFR Part 68, the Administrative
Council on Terminal Attachments ("ACTA")-adopted technical criteria TIA-968-A, "Telecommunications -
Telephone Terminal Equipment -Technical Requirements for Connection of Terminal Equipment To the Telephone
Network, October 2002."
Patrick Murphy
Senior Vice President, Chief Financial Officer
Hotwire
6381-Ax-2xx
th
Avenue North
17