Connecting To The Auxiliary Port - Cisco ASR 903 Hardware Installation Manual

Chapter 3 Installing the Cisco ASR 903 Router
Run the setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 1
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 2
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 3
When the Remove the Program window appears, click Remove.
Step 4
Step 5 When the InstallShield Wizard Completed window appears click Finish.
Uninstalling the Cisco Microsoft Windows Vista USB Driver
This procedure shows you how to uninstall the Microsoft Windows Vista USB driver.
Note
Run the setup.exe for Windows 32-bit or setup(x64).exe for Windows-64bit. Click Next.
Step 1
The InstallShield Wizard for Cisco Virtual Com appears. Click Next.
Step 2
When the Program Maintenance window appears, select the Remove radio button. Click Next.
Step 3
Step 4 When the Remove the Program window appears, click Remove.
Note
Step 5 When the InstallShield Wizard Completed window appears click Finish.

Connecting to the Auxiliary Port

When a modem is connected to the auxiliary port, a remote user can dial in to the router and configure
it. Use a light blue console cable and the DB-9-to-DB-25 connector adapter.
Note
OL-25178-04
Disconnect the router console terminal before uninstalling the driver.
If a User Account Control warning appears, click "Allow - I trust this program..." to proceed.
The console cable and DB-9-to-DB-25 connector are not included with the
Cisco ASR 903 Router; they are ordered separately.
Connecting the Cisco ASR 903 Router to the Network
Cisco ASR 903 Router Hardware Installation Guide
3-33