Chapter 3 Installing The Cisco Asr 903 Router; Installing The Chassis Brackets - Cisco ASR 903 Hardware Installation Manual

Installing the Router in a Rack

Installing the Chassis Brackets

The chassis is shipped with mounting brackets that can be installed on the front or rear of the chassis.
To install the brackets on the front of the chassis, perform these steps:
Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
Step 1
Figure 3-1
Figure 3-1
Figure 3-2
Figure 3-2
Step 2 Position one of the brackets against the chassis side, and align the screw holes.
Step 3 Secure the bracket to the chassis with the screws removed when performing Step 1. The recommended
maximum torque is 28 in.-lb (3.16 N-m).
Step 4 Repeat Step
Cisco ASR 903 Router Hardware Installation Guide
3-2
shows how to attach the brackets on the Cisco ASR 903 Router for a 19-inch EIA rack.
Attaching Mounting Brackets for a 19-inch EIA Rack
shows how to attach the brackets on the Cisco ASR 903 Router for a 300 mm ETSI cabinet.
Attaching Mounting Brackets for a 300 mm ETSI Cabinet
2 and Step 3 for the other bracket.
Chapter 3 Installing the Cisco ASR 903 Router
OL-25178-04