Mid Band Agc; Pres Band Agc (Presence Band Agc); High Band Agc; Low Band Limiter - Omnia ONE Installation And Operation Manual

Stereo audio processor with sensus
Table of Contents

Advertisement

RTZ Speed (Return To Zero Speed)
RTZ stands for Return To Zero. What RTZ does is return the gain of the AGC band to the selected
amount of gain reduction (See RTZ Level below) in the absence of audio. RTZ speed controls
how fast this adjustment takes place – i.e., how long it takes the AGC to move to the target RTZ
level.
RTZ Lvl (Return To Zero Level)
This control adjusts the gain level to be achieved by the AGC section during lapses in audio. The
primary purpose of RTZ is to prevent the AGC from increasing the gain unnecessarily during
lapses in audio, which would result in an increase in noise level.
<-Exit
Click on this option to return to the Adjust Processing submenu.

Mid Band AGC

See description of settings for Low Band AGC

Pres Band AGC (Presence Band AGC)

See description of settings for Low Band AGC

High Band AGC

See description of settings for Low Band AGC

Low Band Limiter

LFLim Drv (Low Frequency Limiter Drive)
Adjusts the drive level to the individual Limiter band. Used when you desire more or less density
in a specific band. These Limiter Drive controls can also be used as secondary dynamic EQ
controls after the Drive controls in the AGC Xover.
To adjust the overall amount of density, use the Overall Limiter Drive control in the Xover
section. See "OV Lim Drv" in the
LFLim Att (Low Frequency Limiter Attack)
The attack control adjusts how fast the limiter responds to sudden increases in audio level, and
higher numbers equate to faster response times. Faster attack times reduce the transient nature of
the input audio, while slower attack times improve it. Extremely slow attack times must be used
with caution so as not to allow the Final Limiter stage to be overloaded during the time when the
limiter is adjusting the level downwards.
LFLim Rls (Low Frequency Limiter Release)
OmniaONE Multicast - Use and Operation Manual – Version 0.90
Xover (Crossover)
section on Page 37.
39

Advertisement

Table of Contents
loading

This manual is also suitable for:

One multicast

Table of Contents