A report similar to the below will be generated.
You can select the text and then copy and paste into an email or email a screen shot to if requested to do so by your
Telos/Omnia factory Customer Support Engineer. For contact information, see
Obtaining Service
on Page 60.
Electrical and mechanical safety note!
When the Omnia is operated with its chassis top cover removed, you are exposed to potentially lethal voltages.
Before attempting to make voltage measurements, be forewarned that the power supply heat sinks are connected to
the AC power line. Avoid these areas whenever the AC power cable is attached to the Omnia. Never attempt to
make measurements when the power supply's safety cover is removed.
When reinstalling the top cover, make certain that all thirty screws are replaced, and that they are tightened to a snug
fit. Operating the unit with its cover removed or without all of the retaining screws will void your warranty and may
compromise the ability of the Omnia to operate in high RF environments.
Narrowing down problems
OmniaONE Multicast - Use and Operation Manual – Version 0.90
58