Accent Glass Installation; Lk8 Light Installation (Optional) - Napoleon Torch GT8P Installation And Operation Instructions Manual

Hide thumbs Also See for Torch GT8P:

Installation and operation manual (84 pages)

Installation and operating instructions manual (88 pages)

Installation and operation instructions manual (22 pages)

Table Of Contents

Table of Contents

Carefully sprinkle the accent glass onto the glass support

evenly. Ensure no glass falls into the burner area. If this

happens, insert a clean bag into your vacuum cleaner and

vacuum out the accent glass. Replacement accent glass

can be purchased from Wolf Steel Ltd.

1. Turn off the electrical and gas supply to the ﬁ replace.

2. Remove the frame from the unit by removing the 2 black securing

screws from the top, and the 2 silver hex head securing screws from

the bottom.

3. Lay the frame down on its front, being careful not to scratch the

ﬁ nish.

4. Starting at the top of the frame, take one light assembly and carefully

snap it into place in the hole provided. Repeat for each of the light

assemblies. The wires on the top 2 light assemblies will need to be fed

in behind the heat shields.

Note: When installing the light kit be careful not to scratch your

ﬁ ngers on any of the exposed screws in the frame.

5. Using Figure 31 as a guide, connect the light assemblies to the

appropriate ﬂ ags on the wire harness. The wire harness is labeled (TR)

top right, (BR) bottom right (TL) Top left and (BL) bottom left.

6. Secure the wires into the clips at both sides and the bottom of the

frame. Use the extra clips provided to retain any loose wires.

7. Re-attach frame onto unit.

8. Remove the control panel by removing the 2 screws securing it along

the top edge. Leave the wires connected to the ON/OFF switch.

9. Place the transformer into the bottom of the unit. Plug the transformer

into the receptacle.

10. Lay the control panel ﬂ at along the bottom edge of the frame. Attach

one of the wire leads from the transformer to the lead on the wire harness

labeled "TRANS", and the other to the ON/OFF switch. Attach the last

lead on the wire harness labeled "SWI" to the ON/OFF switch.

11. Re-secure the control panel.

12. Turn on the gas supply and electrical power.