Frame/Front Installation - Napoleon Torch GT8P Installation And Operation Instructions Manual

Hide thumbs Also See for Torch GT8P:

Installation and operation manual (84 pages)

Installation and operating instructions manual (88 pages)

Installation and operation instructions manual (22 pages)

Table Of Contents

Table of Contents

1. Align the two holes in the upper

portion of the hinge on the control door

to those in the bottom trim bracket,

secure using two of the #8 x 1/2" hex

head screws supplied. Figure 26

2. Install the top trim bracket to the

ﬁ rebox using the three #9 - 14 x 1/2"

hex head screws supplied in the

manual baggie.

3. Rest the top lip of the

frame on the top trim bracket, and

the securing tabs at the bottom of the

frame on the bottom trim

bracket.

4. Align the two slots in the top of the

top trim bracket and secure using the two #10 pan head screws supplied however

do not fully tighten to leave room for adjustment. Figure 27

5. Align the holes in the securing tabs at the bottom of the

the holes in the bottom trim bracket and secure using the two remaining #8 x 1/2"

hex head screws, however do not fully tighten to leave room for adjustment.

Figure 27

6. If required, the bottom trim bracket can be adjusted by loosening it's securing

screws. Figure 27

7. Once the

frame is perfectly square and the control door will close

without rubbing against the sides of the

8. Open the control door.

9. Insert the door stop chain into the receiving slot in the control door.

Figure 29

10. Insert the door stop chain into the receiving slot in the

that when fully open the control door has a clearance of 1/8" to the ﬁ nished wall.

NOTE: In most cases, a count of 9 balls between receiving slots will give the

desired clearance. Figure 29

11. Close the control door.

The

frame has been designed to accommodate ﬁ nished material

thicknesses of .500" - .750". If it is necessary to pull the

the max. .750" the magnetic catch will need to be adjusted. Minor adjustment can

be made by removing shims from behind the magnet. Major adjustments can be

made by moving the magnet to the outside of the panel.

Adjustment may be required to accommodate

the door stop chain slack when the control door

is closed. The control door securing screws

can be loosened to allow adjustment. Before re-

tightening the screws ensure the control door is

still recessed into the

offset to the top trim piece.

W415-0619 / B / 03.03.08