How To Use Vacuum And Accessories; How To Clear A Blockage - Eureka 990 Series Owner's Manual

How to use vacuum and accessories

Never use vacuum without all filters in place.
!
Empty dust cup after each use.
Make sure vacuum is turned off before connecting or disconnecting hose, telescoping wand, or tool.
When pulling out power cord, watch for a yellow
line on cord. Continue pulling cord slowly; stop
pulling when you see the red line! The red line
indicates the end of usable cord.
• Pull out cord to desired length (Fig. 1) and plug
into electrical outlet.
• Adjust floor nozzle brush lever. For hard floors,
press lever down to extend brushes (Fig. 2).
For carpeted floors, pull lever up to retract
brushes.
• Step on power switch to turn on vacuum (Fig. 3).
• To lengthen wand, push wand release button
and pull to extend telescoping wand (Fig. 4).
• For accessories, push tool onto end of wand or
directly onto hose handle; twist to tighten (Fig. 5).
• When vacuuming delicate surfaces such as
drapes or picture frames, slide hose suction
control to reduce suction (Fig. 6).
• When finished vacuuming, step on cord rewind
switch to retract cord. Guide the cord with hand
to be sure it does not whip around and cause
damage.
Crevice tool
Use for baseboards, corners and furniture.
Push crevice tool onto end of wand.
Dusting brush
Use for furniture, drapes and vents. Push
dusting brush onto end of wand (Fig. 5).

How to clear a blockage

Make sure vacuum is turned off.
Watch for sharp objects.
• Pull floor nozzle off wand and check for
blockage (Fig. 7).
• Flex hose to clear any blockage (Fig. 8).
Eureka Customer Service HELPLINE 1-800-282-2886
Fig. 1
Fig. 3
Fig. 5
Fig. 6
Fig. 7
Fig. 2
Fig. 4
Fig. 8
www.eureka.com
5