How To Assemble - Royal Vacuum Cleaner Owner's Manual

HOW TO ASSEMBLE

TOOL REQUIRED: PHILLIPS SCREWDRIVER
1.
Midsection
Cord
Tabs
Base
Stand base in upright position. Push midsection onto
base by aligning tabs on the backside of midsection
and the pockets on the backside of base. Assemble
the two (2) lower handle screws in the following
manner: while holding nut in place, insert screw
through front of midsection and tighten.
NOTE: Make sure the power cord is out of the way to
avoid pinching.
3. 3a.
2.
Upper Handle
Slide upper handle down onto unit. Place screw into
recess in back of upper handle and tighten.
Place solution reservoir into
cleaner and tilt back until it
snaps into place.
6