Preparing The Carpet; How To Operate - Royal Vacuum Cleaner Owner's Manual

PREPARING THE CARPET

IMPORTANT: DO NOT USE THE CARPET SHAMPOOER AS A DRY VACUUM.
1. Vacuum carpet thoroughly. Use a Royal ® vacuum cleaner with a revolving brushroll for best results.
2. Remove as much furniture from the room as possible. If unable to remove the furniture, place plastic or foil
under and around the legs until the carpet has dried completely.
CHECK FOR COLOR FASTNESS:
Before cleaning carpet/upholstery, test for color fastness. Dampen a white cloth with solution. Test a small area in
a closet or under a cushion. Gently rub the cloth over the area. Check each color for color bleeding. If the cloth
remains clean, it should be safe to clean the carpet/upholstery.
HELPFUL HINTS FOR CLEANING CARPET:
1. Do not oversaturate carpet with cleaning solution while using the Carpet Shampooer.
2. For heavily soiled areas, additional applications may be necessary.
3. Allow plenty of time to dry carpet thoroughly.
4. Wipe cleaning solution from woodwork and wood to prevent any damage.
5. Try not to walk on carpet until it is completely dry.
6. After carpet is thoroughly dry, vacuum the carpet using a cleaner with a revolving brushroll.
7. Before cleaning, determine where you will start and end, making sure not to walk over previously cleaned
areas.
AFTER CLEANING:
• Allow carpet to dry completely. Try not to walk on the carpet until it is dry.
• If you need to walk on the carpet, place white towels on the areas you want to walk.
• If the carpet is not dry and the furniture must be placed back in the room, use plastic or foil under the furniture
to prevent staining the carpet.
• Thoroughly clean the dirty water tank with hot tap water. See page 11.
WARNING: DO NOT STORE THE CARPET SHAMPOOER IN
GARAGE OR AREA WHERE UNIT COULD FREEZE.

HOW TO OPERATE

NOTE: Use only Royal ® Carpet & Rug Shampoo. Using other cleaning solutions may cause excessive foaming.
Excessive foam will cause the float to shut off the vacuum prematurely. Using other cleaners will void your
warranty.
REMOVE AND REPLACE SOLUTION RESERVOIR
1a.
1. 2.
Press clean solution Unscrew measuring cap
reservoir latch (Diagram from back side of solution
1). Tilt solution reservoir reservoir.
away from cleaner and
remove (Diagram 1a).
3. 4.
Fill measuring cap with Fill remaining
solution 5 times, reservoir with hot tap
(approximately 5 oz.). water. Replace measuring
cap.
8
solution