Table of Contents
Advertisement
I
c Press the
(sET/EJEcTj
button. The printer will feed the
fanfold paper back until it is out of the way.
Move the release lever to the back ( ~ ) position.
Place the paper guide in the upright position.
Load single sheets as described in "Loading cut sheet
paper" on page 26.
Unparking the paper
When you have finished printing on cut sheet paper and
you want to start printing again on fanfold paper, here's
how you do it:
Remove any cut sheets which may still be in the
printer.
Place the paper guide in the horizontal position.
Move the release lever to the front ( N ) position. The
printer will beep if you move the lever while paper is
still loaded ready for printing.
Press the
[SET/EJECT]
button. The parked fanfold paper
will be fed into the correct position ready for printing
again.
Page32
Advertisement
Table of Contents
