Table of Contents
Advertisement
Set the paper position to the top of a page (where you
want the printing to start on each page) using the
micro-feed functions (page 35).
. Press and hold down the (~]
button.
While holding down the (15iTEF@ button, press the
m
button.
. Release both buttons. The display will show "--",
which means that the top of the form has been set.
. Put the printer back into
ready mode.
Note:
The printer now "knows" the top of a page, but it doesn't
know the exact page unless you tell it, which means that
when you do a page feed, the printer will not necessarily
move to the correct position on the next page. You must set
the page length using the Electronic DIP Switch mode
described on page 53.
Changing the autoloading position
When you load cut sheet paper, the printer automati-
cally loads the paper so that printing starts one line
from the top of the paper, unless you tell it otherwise.
This is how you tell it otherwise (for example, if you're
printing a lot of letters on letterhead paper):
c With the printer in
not-ready
mode, load cut sheet
paper using the
[SET/EJECT]
button.
" Use the micro-feed functions (page 35) to alter the
print position. Notice that a number will appear in
the LCD window. This means you can remember that,
for instance, "we should print starting from 67 steps
down on headed invoices". If the value goes over 99
steps, the display changes from "99" to "--".
Set the printer back in
ready mode.
All
cut sheet paper loaded from now on will be loaded
so that printing starts at.this position, until you
Page36
Advertisement
Table of Contents
