Relay Devices Worksheets - Honeywell Ademco Vista-50P Programming Manual

Relay Devices Worksheets

Applicable only if relays (4204), or X-10 devices are used.
Relays are programmed in the #93 Menu Mode in the Relay Programming Section. Fill in the required data on the
worksheet below and follow the procedure in the Installation and Setup Guide as you enter the data during the displays
and prompts that appear in sequence.
Notes: 1. For 4204 the Device Programming section must be programmed for the device address. Set the DIP
switches on the device for that address.
2. For X-10 devices, use the 1361X10 transformer in place of the transformer that comes in the box with the
control panel.
S T A R T
OUTPUT
A
DEV #
EV/ZL
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
A = DEVICE ACTION
EV = EVENT
ZL = ZONE LIST
S T O P
ZT / P ZL ZT / P
0 = No Response; 1 = Close for 2 sec; 2 = Close and stay closed; 3 = Pulse on and off
0 = Not used; 1 = Alarm; 2 = Fault; 3 = Trouble; 4 = Restore
1-8, 0 = Not Used
"START" ZONE LIST:
"STOP" ZONE LIST:
Relay 1=4204
Restrict
Group 2=X-10
Upon alarm, fault, trouble or restore of ANY zone in this list, device
action will START.
Upon restore of ALL zones on this list, device action will STOP. It
need not be same list as used for START.
— 39 —
Relay # for
Dev Add 4204
4204 or
or House Code
Unit Code for
for X-10
X-10