Garage Door Opener Operation; General Information; Enrolling The 5877 Relay Receiver; Garage Door Feature Operation - Honeywell LYNX Touch L5210 Series Manual

Home Automation

Garage Door Opener Operation

General Information

If your system has been equipped with a 5877 Relay Receiver and 5822T Tilt Sensor or Door/Window
Transmitter (i.e.; 5616), it can be used to remotely operate and/or view the status of up to three Garage Doors.
The System can be armed when the garage door is open, and once the garage door has been closed, the zone will
be monitored as part of the system without providing burglary protection. It can also be programmed for
monitoring only. The panel includes the option to automatically close the Garage Door(s) if it has been left open
for more than a specified (programmable) period time or at a specified time.
Do not use the LYNX Touch garage door automation with any garage door opener that lacks the safety
features required by U.S. federal safety standards (this includes any garage door opener model manufactured
before January 1, 1993). A garage door opener that cannot detect an object and stop and reverse the doo –
does not meet current U.S. federal safety standards. Your garage door opener also must signal before
unattended door operation. For more information please consult your garage door opener manual.
• Ensure that the 5877 Relay Receiver is in close proximity to the LYNX Touch while it is being enrolled. After the
Notes:
device has been enrolled it can be mounted in its permanent position but should be tested to make sure that it
receives the Open/Close signals from the LYNX Touch.
• System Status is desired, a House ID must be enrolled in the LYNX Touch. Refer to the System Type Programming
Section of the LYNX Touch Installation and Setup Guide P/N 800-19974 (or higher) or to the LYNX Touch
Programming Guide P/N 800-19976 (or higher) OR 800-20379 (or higher) (Canada).
• The 5877 Relay Receiver should be enrolled in the LYNX Touch before it is permanently mounted.
• In order to display the garage door status, you must also enroll a 5816 sensor or a 5822T Tilt Sensor. Refer to the
Zone Programming Section of the LYNX Touch Installation and Setup Guide P/N 800-19974 (or higher) or to the
LYNX Touch Programming Guide P/N 800-19976 (or higher) OR 800-20379 (or higher) (Canada).
•
The 5816 or 5822T is enrolled on Zones 45, 46, 47 or 48 (which are reserved for the Garage Door operation) as
Loop 3.

Enrolling the 5877 Relay Receiver

Step
1. At the Home screen select the "Automation" icon.
2. At the second page of the Automation Screen, select the Garage door setup icon.
3. Select the Garage door to be enrolled, from the displayed list.
4. Select "Assign device". The control advances to the Garage Door operation screen.
5. Enter the 7-digit serial number associated with the 5877 Relay Receiver then select "Done".
6. To confirm enrollment, at the LYNX Touch select the "Learn" button and listen for a click at the relay.
7. Select the "" button to return to the Automation screen.

Garage Door Feature Operation

• The Garage Zone and Response Type must be assigned to in order to view garage door status.
Notes:
• The Switches button on the Garage Door Setup screen is used to assign a Z-Wave Binary Garage Door Opener.
• The RF Openers on the Garage Door Setup screen is used to assign RF Garage Door Openers.
Step
1. At the Dashboard screen select the "Automation" icon.
2. At the Automation Screen, select the Garages icon.
3. Select the Garage door that you wish to control/program from the displayed list. The control advances to the Garage
Door operation screen.
4. Refer to the table and procedures below for additional operation/programming information.
Action
Action
- 18 -