Projector Management Using Snmp - Christie DWU951 User Manual

8. Other Functions

8.2 Projector Management using SNMP

The SNMP (Simple Network Management Protocol) enables to manage the
projector information, which is a failure or warning status, from the computer on
the network.
NOTE
• It is recommended that SNMP functions are executed by a network
administrator.
• SNMP management software must be installed on the computer to monitor
the projector via SNMP.
Standard MIB (MIB-2)
You can refer the following items defined in system group of Standard MIB (MIB-2).
Item
sysName
sysLocation
sysContact
Enhanced MIB
You can get configuration information by using Enhanced MIB for projectors.
Enhanced MIB for projectors can be downloaded from [Port Settings] page in
Projector Web Control.
Trap
When an error or warning occurs in the projector, a notification can be sent to the
specified address.
In addition to e-mail alert shown in 8.1 Email Alerts (&87), the following
notification can be sent.
Item
Cold Start
Authentication Failure
DWU951/DWX951/DXG1051 User's Manual - Network Guide
Projector name is set.
The information on where it is located. It has character string
set in sysLocation (SNMP) in Projector Web Control - [Network
Settings] - [Common Setup].
The information on the administrator's contact information. It
has character string set in sysContact (SNMP) in Projector
Web Control - [Network Settings] - [Common Setup].
When the projector is supplied with the power, it works as
below.
• If the STANDBY MODE is set to the NORMAL: the projector's
power status changes from "OFF" to "Standby state".
• If the STANDBY MODE is set to the POWER SAVE: the
projector's power status changes from "Standby state" to "ON
(lamp is turned on)".
(
SETUP menu in the Operating Guide).
&
The SNMP access is detected from the invalid SNMP
community.
90
Description
Description
020-000662-01 Rev. 1 (01-2014)