Other Scan Settings - Xerox DocuColor 3535 User Manual

Other Scan Settings

Scan Service
Memory Full Procedure
Maximum Stored Pages
Lighter/Darker Level
4– 5 4
This section describes how to set other scanner-related settings.
The following items can be configured in Other Settings.
Set whether or not to enable scan features. The default is
Enabled.
Set the processing method when the scanner runs out of memory
during scanning. Set whether or not to enable documents stored
so far.
Enter the setting on the Numeric Keypad using the numbers listed
in the following table. The default is 1, Enabled.
Setting
0
1
Set the maximum number of stored pages for scanning. Set any
number between 1 ~ 999.
Enter the number of the pages using the Numeric Keypad. The
default is 999.
Set the default for the density assigned to Lighter ~ Darker in
Lighter/Darker/Contrast on the Image Quality/File Format screen
in Scan mode. Set the density between -100 ~ +100 in increments
of 1.
Lighter (+3) ~ Lighter (+1) must be set between -100 and -1, and
Darker (+1) ~ Darker (+3) must be set between +1 ~ +100.
Normal, 0, cannot be changed. Set so that the values increase
from Lighter (+3) to Darker (+3).
Select scanning density using the up and down arrow buttons on
the left, and set the value using the up and down arrow buttons on
the right.
Description
Disabled (Discard
stored documents)
Enables stored data
Xerox DocuColor 3535 Printer/Copier