Table of Contents
Advertisement
Using a handset as a room monitor
Ending a conference call
a
Press the end call key.
If an internal participant presses the end call
key a, the other handset remains con-
nected to the external participant.
Accepting/rejecting call waiting
If you receive an external call during an
internal call, you will hear the call waiting
tone (short tone). With Calling Line Identifi-
cation, the caller's number will appear in the
display.
Ending an internal call, accepting an
external call
§Accept§
Press the display key.
The internal call is ended. You are connected
to the external caller.
Rejecting the external call
§Reject§
Press the display key.
The call waiting tone is turned off. You
remain connected with the internal partici-
pant.
Changing the name of a
handset
The names "INT 1", "INT 2" etc. are assigned
automatically on registration. You can
change these names. The name must be no
more than 10 characters. The changed name
is displayed in every handset's list.
u
Open the list of handsets. Your
own handset is indicated by <.
s
Select handset.
§Options§
Open menu.
Rename
Select and press
~
Enter the name.
§Save§
Press the display key.
62
§OK§
.
Changing a handset's
internal number
A handset is automatically assigned the
lowest free number when it is registered. If
all slots are occupied, number 6 is overwrit-
ten if this handset is in idle status. You can
change the internal number of all registered
handsets (1–6).
u
Open the list of handsets. Your
own handset is indicated by <.
§Options§
Open menu.
Assign Handset No.
Select and press
r
Select number.
§Save§
Press the display key to save the
input.
Using a handset as a
room monitor
If the room monitor is activated, a previously
saved destination number is called as soon
as a set noise level is reached. You can save
an internal or external number in your hand-
set as the destination number. All of the
handset keys are deactivated, with the
exception of the display keys.
The room monitor call to an external
number is terminated after approximately
90 seconds. The room monitor call to an
internal number (handset) stops after
approx. 3 minutes (depending on the base).
When the room monitor is activated, all keys
are locked except the end call key. The hand-
set's speaker can be switched on or off (Two
Way Talk = On or Off). If Two Way Talk is swit-
ched on, you can answer the room monitor
call.
When the room monitor is activated, incom-
ing calls to the handset are indicated with-
out a ringtone and are only shown on the
screen. The display and keypad are not illu-
minated and advisory tones are also turned
off.
§OK§
.
Advertisement
Table of Contents
