Replacing An Olx Divider - HP Integrity rx4640 User's & Service Manual

Removing and Replacing Components
Removing and Replacing OLX Dividers

Replacing an OLX Divider

To replace an OLX divider, follow these steps:
Step 1. Insert the OLX divider into the available slots on the I/O baseboard and push down firmly to seat it
into the slots.
Step 2. At this point, if you are replacing the entire OLX divider rack on to the I/O baseboard, replace the
four torx T15 fasteners.
Step 3. Slide the latch on the rear OLX divider wall closed, to lock the rear edge of the PCI divider.
Figure 4-28 shows how to close the OLX divider latch.
Step 4. Push down on the manual retention latch until it locks into the chassis wall.
Step 5. Replace the top cover. See "Replacing the Top Cover" on page 44.
Step 6. Replace the front bezel. See "Replacing the Front Bezel" on page 41.
Step 7. If rack mounted, slide the HP server into the rack until it stops. See "Inserting the Server into the
Rack" on page 39.
84
Chapter 4