Installation; Installation Overview - Extron electronics SW HDMI LC User Manual

Installation

This section describes the installation and setup of the SW HDMI LC switchers, including:
z z
z z
z z
z z
z z
z z

Installation Overview

To install and set up the SW HDMI LC switcher:
1
2
3
4
5
6
7
8
9
Installation Overview
Rear Panel Features
Wiring the Power Connector (Optional)
HDMI Video Connectors Pin Assignments
Wiring for RS-232 Control
Enabling Auto-input Switching
Mount the switcher on a rack shelf or furniture, if desired. See
SW HDMI LC" in the "Reference Information" section.
Connect HDMI input sources to one or more of the SW HDMI LC input connectors.
Connect an output device to the HDMI output connector on the switcher rear panel.
Wire an RS-232 cable to pins 1, 2, and 3 of one of the provided 5-pin captive screw
plugs. Insert this plug into the 5-pin Remote/Auto-SW connector on the switcher's rear
panel, and connect the other end of the cable to your computer. (See
RS-232 Control," later in this section.)
(Optional) If you want to enable auto-input switching, use a jumper to connect pins
4 and 5 of the 5-pin captive screw plug that you plugged into the Remote/Auto-SW
connector in step . (See "Enabling Auto-input
4
If using a different external power supply from the one provided with the switcher,
wire a 2-pin captive screw connector to your power supply. (See
Connector (Optional)," later in this section.)
Power on the output display.
Connect power to the switcher.
Power on the input devices.
"Mounting the
"Wiring for
Switching," later in this section.)
"Wiring the Power
SW HDMI LC • Installation 3 3