Setting A Dmx Address - Philips iPlayer 3 User Manual

• Testing a DMX address. See Testing a DMX Address on page
36.
Use the arrow keys to navigate the Setup Menu and enter
values.
Note: In the Setup Menu, your changes are saved automatically each
time you enter a new value.

Setting a DMX Address

When you use the iPlayer 3 to set a light fixture's DMX address,
you have two options for specifying which fixture(s) to address.
You can set all connected fixtures to a single DMX address, or
you can specify a DMX address for each individual light fixture.
1. Access Configuration Mode by pressing the right arrow
button on the iPlayer 3 faceplate.
2. From the Configuration Mode main menu, select
then press the right arrow.
3. Select
S
ET
4. If you want to specify a DMX address for all of the lights,
select
A
LL
5. If you want to specify a DMX address for each individual
light:
a. Select
b. At the
enter the serial number of the light, using integers 00 to FF
hexadecimal (42 00 01 1F, e.g.). The light will blink when you
enter each correct byte.
c. Confirm the serial number by pressing the right arrow.
6. Specify the number of the light (1 through 170)
7. Select
P
ROGRAM
confirm you want to change the address of the light.
, and then press the right arrow.
F DMX A
IXTURE DD
S A
AME DDRESS
.
, and then press the right arrow.
B S N
Y ERIAL UMBER
S/N B 1? S/N B 2? S/N B
YTE YTE
, and then press the right arrow to
DMX A ?
DDR
CONFIGURATION MODE
S
ETUP
and prompts,
3? S/N B 4?
YTE YTE
.
, and
35