DataCard SR200 User Manual page 85

LCD Message
HR Overheat
TR Heater
TR Overheat
TR Thermister
RR Overheat
RR Heater
RR Thermister
Overcool
Head Overheat
Power Intrpt
EEProm Broken
MG Unconnected
MG Mechanical
MG Hardware
MG Test Err
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
Possible Cause
The retransfer or bend
remedy roller is too hot.
The retransfer roller is not
working.
The retransfer roller is too
hot.
The retransfer roller
thermistor is not working.
The bend remedy roller is
too hot.
The bend remedy roller is
not working.
The bend remedy roller
thermistor is not working.
It is too cold for the printer
to operate.
The thermal head is
overheated.
Power was interrupted for
a short time.
EEPROM malfunction
Magnetic stripe module
connection error
Magnetic stripe
mechanical error
Magnetic stripe hardware
error
A write error occurred
during self-test.
Solution
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
The temperature in the printer area is too low. Use at
the recommended operating environment temperature
as described in "Operating environment" on
page 92
.
Turn the power switch off and allow the printer to cool
for approximately 10 minutes before turning power
back on.
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
Turn the power switch off and then on again. Call for
service if the problem persists.
1 Check the type and orientation of magnetic cards in
the card hopper as described in
page 8
.
2 Press Reset, and then Return to initialize the
printer.
"Load cards" on
79