DataCard SR200 User Manual page 51

Error Code Displayed Message
0142A200 Retransfer film has run out.
0142B200 Ink ribbon has run out.
02****** Printer is not found.
05000050 Failure occurred during card loading.
05000051 Card jam near the card feed roller.
05000052 Card jam near the card outlet.
05000053 Top side film has run out.
05000054 Bottom side film has run out.
05000055 Top side film is broken or is not
detected.
05000056 Bottom side film is broken or is not
detected.
05000057 Mark on top side film is not detected.
05000058 Mark on bottom side film is not detected.
05000059 The laminator door is open.
0500005A The film cartridge is detached.
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
Solution
1 Load the Retransfer Film (see
film" on page 11
).
2 Press Reset and then Enter to initialize the
printer.
1 Load the Ink Ribbon (see
page 10
).
2 Close the printer door and press Reset and then
Enter to initialize the printer.
• Make sure that the host PC and the printer are
connected properly.
• Make sure that the printer is switched on.
• Check to ensure that the laminator is properly
connected to the card printer (see
laminator connection" on page 15
• Remove the card.
• The temperature of the heating roller may be
too high, or the card transfer speed may be too
slow. For details on adjusting optimum setting,
please consult an authorized dealer.
• Remove the jammed card.
• Replace the laminate film with a new one.
• Replace the laminate film with a new one.
• Check to ensure that the laminate film is
correctly set.
• Check to ensure that the type of laminate film in
use and the settings are appropriate.
• Check to ensure that the laminate film is
correctly set.
• Check to ensure that the type of laminate film in
use and the settings are appropriate.
• Check to ensure that the laminate film is
correctly set.
• Check to ensure that the laminate film is
correctly set.
• Close the laminator door.
• Insert the film cartridge.
"Load retransfer
"Load ink ribbon" on
"Optional
).
45