Retransfer Section Jam - DataCard SR200 User Manual

Retransfer section jam

Tips – Retransfer jam
Some internal parts may
•
be hot. Be careful when
removing a jammed card.
The card might be very
•
hot. Use the supplied
tweezers to remove
cards from the printer.
Do not drop the card
•
inside the printer.
SR200 & SR300 Printer and LM200 & LM300 Laminator User Guide
If a card jams in the retransfer section, "Jam (Retransfer)" is displayed on the
LCD panel. To remove the jammed card:
Power off the printer.
1
2 Open the printer door.
Press the retransfer film cartridge eject button and remove the
3
retransfer film cartridge.
The card might be stuck to the film. Watch
carefully to avoid jamming the card when
removing the retransfer film cartridge.
If "Please Close Door" appears, the retransfer
film cartridge is stuck. Push it back into the
printer, close the door, and return to step 3.
Remove the card from the printer or from the
4
retransfer film cartridge.
If the card is stuck to the right of the heat roller,
5
see "Transfer jam" on page
If the card is stuck near the
6
Retransfer heat roller, use the
supplied tweezers to remove the
card, as shown.
Replace the retransfer film
7
cartridge and close the printer
door.
8 Power on the printer.
Press Reset. "Card Jam
9
Removed?" appears on the
printer LCD panel.
Do not initialize the printer with
the card inside.
— Press Yes only if the card is
removed.
— Press No if the card remains
inside the printer.
Initialize the supplies as
10
described in "Initialize the ink ribbon and retransfer film" on page
73.
17.
75