Draytek Vigor2710 Series User Manual page 152

Profile Name
Enable this profile
Netbios Naming Packet
Always On or Idle Timeout Always On-Check to enable router always keep VPN
Enable PING to keep alive This function is to help the router to determine the status of
PING to the IP
Specify a name for the profile of the LAN-to-LAN
connection.
Check here to activate this profile.
Pass – click it to have an inquiry for data transmission
between the hosts located on both sides of VPN Tunnel while
connecting.
Block – When there is conflict occurred between the hosts on
both sides of VPN Tunnel in connecting, such function can
block data transmission of Netbios Naming Packet inside the
tunnel.
connection.
Idle Timeout: The default value is 300 seconds. If the
connection has been idled over the value, the router will drop
the connection.
IPSec VPN connection, especially useful in the case of
abnormal VPN IPSec tunnel disruption. For details, please
refer to the note below. Check to enable the transmission of
PING packets to a specified IP address.
Enter the IP address of the remote host that located at the
other-end of the VPN tunnel.
144 Vigor2710 Series User's Guide