Light Setting; The Cutting Unit Components; Attaching And Removing The Cutting Unit; Side Shifting The Cutting Unit - Husqvarna PT26 D Operator's Manual

IMPORTANT INFORMATION:
Do not touch the bulb glass with your fingers. Finger
prints evaporate and mark the reflector.
5. Fold the wire loop for headlight lamp to one side
and replace the bulb.
6. Assemble in the reverse order.

Light setting

Place the machine at least 5 m from a wall. The
machine must stand flat.
The steering wheel console must be in the rear
position.
Switch on the headlights.
The low beam's upper limit line must fall 1 cm for each
metre distance to the wall, measure from the centre of
the headlight.
Adjust with the screws (36) if necessary. These are
accessible once the rear plastic cover around the
steering wheel console has been removed.

The Cutting Unit Components

The components mentioned are:
• A Pin
• B Link joint
• C Cutting unit mountings
• D Cutting height settings
• E Propeller shaft with quick couplings
• F Service handle
• G Drive belt with cover
• H Bevel gear

Attaching and removing the cutting unit

WARNING:
Exercise caution. Risk of crush injuries. Wear
protective gloves
See "Side shifting the cutting unit" on page 45.

Side shifting the cutting unit

Cutting unit, Combi 155, can be side shifted 8 cm to
the left or be centrally positioned on the machine.
1. Stop the engine. Switch off the weight transfer switch.
The Cutting Unit Components
Maintenance
45