Cleaning - Husqvarna PT26 D Operator's Manual

2. Maintenance and replacement are required more often in dusty
conditions.
3. With daily use, the machine shall be lubricated twice weekly.
4. Performed by authorised service workshop.
5. After the first 25 hours.
WARNING:
No service operations may be performed on the
engine or cutting unit unless:
• The engine is stopped.
• The parking brake is on.
• The ignition key has been removed.

Cleaning

Clean the machine directly after use. It is much easier
to wash off grass cuttings before they dry.
Oily dirt can be removed using a cold degreasing
agent. Spray a thin layer and wait a few minutes.
Rinse at normal water pressure. Do not direct the jet
towards electrical components or bearings.
Do not rinse hot surfaces, for example, the engine and
exhaust system.
IMPORTANT INFORMATION:
Avoid using a high pressure washer or a steam cleaner.
Lubricate the machine if necessary after cleaning.
Carry out extra lubrication when the bearings have
been exposed to a degreaser or a water jet. There is a
major risk of water penetrating into bearings and
electrical connections. Corrosion attack, which will
lead to running problems. Cleaning additives generally
aggravate the damage.
Check and clean if dirt collects in the area for the
circuit card and on the circuit card. Clean using a dry
method, i.e. with a vacuum cleaner or compressed air.
Do not blow directly on the circuit card. Do not rinse
with water. There is a risk of damaging the circuit card.
Clean the machine immediately after use
Maintenance
37