Maintenance; Maintenance Schedule - Husqvarna PT26 D Operator's Manual

Chapter 6: Maintenance
It is good practice to always check for leaks and loose components after use. Also check the machine and listen for
knocking sounds. During hard use and in extreme conditions, the service intervals should be reduced.
Check the cooling system's antifreeze before the Winter.

Maintenance Schedule

The following is a list of maintenance procedures that must be performed on the machine. Paragraphs that are
marked with footnote number 4, see an authorised service workshop.
● =
Described in this manual
❍ =
Not described in this manual.

Maintenance

Check for fuel and oil leaks
Check the safety switch, seat
Check the safety switch pedal
system, neutral position
Check the engine oil level (at every
refuelling)
Check the hydraulic oil level
Check the coolant level
Check/clean the engine's cooling air
intake, radiator mesh and radiator
Check fastenings (screws, nuts, etc.)
Start the engine and blades, listen for
unusual sounds
Clean under the cutting unit and belt
covers
Check for damage
Check the air pressure in the tyres
(100 kPa)
Clean thoroughly around the engine
Clean thoroughly around the
transmission
Lubricate according to lubrication chart
Clean the air filter and empty the
particle trap
Check the blades
Change the engine oil and filter
Replace hydraulic oil filter and check
4, 5
the oil level
Check the tension and condition of
the belts (generator belt, power take-
off belt, cutting unit belt)
Page Daily main-
tenance
befor after
❍
-
●
43
●
43
●
113
●
115
●
50
38
-
-
48
-
41
-
-
3 111
40
50
1 114
115
38
50
51
Weekly Maintenance interval hours
main-
250
tenance
●
●
●
● ● ●
❍
❍
● ● ●
❍
●
❍
❍
● ●
●
●
●
●
●
Maintenance
500 1000 2000
●
3000
35